09-27-2020, 03:54 AM
Hi,
just installed my OAP setup into my car and everything works great except for the reverse camera view. I wired an optical coupler to my reverse lamp circuit and ran the other side to the pi up on the dash to GPIO pin 23. I set the reverse camera to the latter pin in the reverse camera settings within OAP, but when I shift into reverse the view does not switch over automatically. I used a multi-meter to confirm the reverse lamp wire I ran is in fact powered, which it is. Any ideas why the view isn't switching over?
Thanks in advance.
just installed my OAP setup into my car and everything works great except for the reverse camera view. I wired an optical coupler to my reverse lamp circuit and ran the other side to the pi up on the dash to GPIO pin 23. I set the reverse camera to the latter pin in the reverse camera settings within OAP, but when I shift into reverse the view does not switch over automatically. I used a multi-meter to confirm the reverse lamp wire I ran is in fact powered, which it is. Any ideas why the view isn't switching over?
Thanks in advance.