11-01-2020, 04:59 AM
Hello all,
I've just installed a OAP and I've got almost everything working properly. My only hold up right now is I can't get the picam working with OAP at all. The 'Rear Camera' button only pulls a blank screen.
raspistill does errors with the following:
Normally, I would assume this was a simple connection issue. I've verified 100% that the camera module works and all physical connections are good to go. I've flashed a fresh raspbian image and installed it in the same hardware setup, and the camera functions normally there, but when OAP is installed, I can't get the camera working.
This definitely seems like a software issue with OAP, but I can't seem to pin down exactly what's going wrong.
Any help is appreciated. I'll be happy to provide any additional info if needed.
Thanks!
I've just installed a OAP and I've got almost everything working properly. My only hold up right now is I can't get the picam working with OAP at all. The 'Rear Camera' button only pulls a blank screen.
raspistill does errors with the following:
pi@raspberrypi:~ $ raspistill -v -o still.jpg
mmal: Cannot read camera info, keeping the defaults for OV5647
"raspistill" Camera App (commit f73fca015d42 Tainted)
Camera Name OV5647
Width 2592, Height 1944, filename still.jpg
Using camera 0, sensor mode 0
GPS output Disabled
Quality 85, Raw no
Thumbnail enabled Yes, width 64, height 48, quality 35
Time delay 5000, Timelapse 0
Link to latest frame enabled no
Full resolution preview No
Capture method : Single capture
Preview Yes, Full screen Yes
Preview window 0,0,1024,768
Opacity 255
Sharpness 0, Contrast 0, Brightness 50
Saturation 0, ISO 0, Video Stabilisation No, Exposure compensation 0
Exposure Mode 'auto', AWB Mode 'auto', Image Effect 'none'
Flicker Avoid Mode 'off'
Metering Mode 'average', Colour Effect Enabled No with U = 128, V = 128
Rotation 0, hflip No, vflip No
ROI x 0.000000, y 0.000000, w 1.000000 h 1.000000
mmal: mmal_vc_component_create: failed to create component 'vc.ril.camera' (1:ENOMEM)
mmal: mmal_component_create_core: could not create component 'vc.ril.camera' (1)
mmal: Failed to create camera component
mmal: main: Failed to create camera component
mmal: Camera is not enabled in this build. Try running "sudo raspi-config" and ensure that "camera" has been enabled
Normally, I would assume this was a simple connection issue. I've verified 100% that the camera module works and all physical connections are good to go. I've flashed a fresh raspbian image and installed it in the same hardware setup, and the camera functions normally there, but when OAP is installed, I can't get the camera working.
This definitely seems like a software issue with OAP, but I can't seem to pin down exactly what's going wrong.
Any help is appreciated. I'll be happy to provide any additional info if needed.
Thanks!