05-07-2022, 01:56 AM
(This post was last modified: 05-07-2022, 02:04 AM by BoostedGS300.)
(05-04-2022, 02:24 PM)BlueWave Wrote:(05-04-2022, 02:20 PM)BoostedGS300 Wrote:(05-03-2022, 10:37 PM)BlueWave Wrote: Please contact us at contact@bluewavestudio.io. We will send you wiring instructions of the iDrive Gen1 controller. Please include your order number in the message.
I had already received this email prior, I looked over it again and the wiring doesn't apply to my controller.
I am going to order another controller to be sure, it's possible mine is defective and troubleshooting up to now hasn't revealed any problems. I will update after I get a new unit and try again.
Thanks for the help everyone.
Please post picture of your iDrive controller and its socket. It is needed to use only CAN and power pins of the controller (others remain not connected). Just in case try to apply wiring instructions we sent you and check if that works.
Please see the attached image for a picture of my controller socket. I will try with your wiring diagram just in case, but my colors don't match and wires for pins 4/5 are twisted pair which leads me to believe that's CAN.
I owe everyone an apology for not trying the Bluewave suggested wiring diagram. It did indeed work. I saw a lot of posts on other sites showing CAN as pins 4/5 and different wire colors but apparently that's not applicable here.
Thanks Bluewave studio for making this incredible software, and the great support.