[Obd]
; List of the AT commands that will be sent to the ELM327 adapter after connection establishment. AT commands can be used to select OBD-II protocol variant, reset the ELM327 adapter or adjust various parameters, e.g. internal timers of the adapter. More info can be found at https://www.elmelectronics.com/wp-content/uploads/2016/07/ELM327DS.pdf
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdAdapterStartupSequence=ATZ;ATE0;ATS0;ATL0;ATH0;ATSP0
; Path to the ELM327 device descriptor (e.g. /dev/ttyUSB0). Relevant only for adapters connected via USB.
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdAdapterDescriptor=
; Baudrate of the ELM327 serial interface. This is the baudrate used to communicate between ELM327 adapter and Raspberry PI. It has nothing to do with baudrate of the OBD port. Relevant only for adapters connected via USB. More information about supported baudrate can be found in user manual of used ELM327 adapter.
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdAdapterBaudrate=115200
; Delay in ms between each request of a PID value. Lowering the period will increase refreshment rate of PID values. Increasing the period may improve stability of the connection (in case of any problems).
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdProbePeriod=5
; Type of the ELM327 adapter.
; (0 - None, 1 - USB, 2 - Bluetooth).
; Setting this value to 0 (None) disables OBD-II feature.
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdDeviceType=0
; MAC address of the ELM327 Bluetooth adapter.
; Example: 00:11:22:33:44:55.
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdAdapterRfCommAddress=
; Id of the RfComm channel exposed by the ELM327 Bluetooth firmware. Relevant only for adapters connected via Bluetooth. More details about RfComm channel ID can be found in user manual of used adapter.
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdAdapterRfCommChannel=1
; Number of allowed NO DATA responses received from ELM327 adapter after querying PID values. Exciding the limit will result in reset of the connection to the adapter.
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ObdMaxNoDataResponseCount=20