11-22-2020, 09:23 PM
(This post was last modified: 11-22-2020, 11:07 PM by peetereczek.)
Ok, I found that command AT SH 00 07 E0 will switch communictaion to 7E8 can ID ECU and PID 015C returned value 7E8037F0112
Little step in the understanding
And with below config
[ObdPid_10]
Query=015C
PreCommands=AT SH 00 07 E0
PostCommands=
Formula=a
Unfortunately value is not being returned correctly :|
There are no errors in the log, gauge display constant value 18, which is not true
Edit: ah, so module is responding with 7F code, which means that it doesn't understood the request...
Little step in the understanding
And with below config
[ObdPid_10]
Query=015C
PreCommands=AT SH 00 07 E0
PostCommands=
Formula=a
Unfortunately value is not being returned correctly :|
There are no errors in the log, gauge display constant value 18, which is not true
Edit: ah, so module is responding with 7F code, which means that it doesn't understood the request...
Car modification enthusiast, riding on Audi A3 8P 2012
https://www.a3-club.net/forum/showthread...ortback-8P
IT guy with truck driving license
https://www.a3-club.net/forum/showthread...ortback-8P
IT guy with truck driving license