07-06-2021, 02:16 AM
I've noticed good response times with Torque also, and it may be an interpolation thing. I'm graphing four O2 sensors and the response is quite good, and if it is interpolating at least i'm getting four sensors per second, rather than a single tachometer reading per second. I may try going through the ELM327 document you posted and see if there are any tuning parameters I could try.
But that's not really the direction I was going with this topic anyway. I'm wondering if there are any ways to pipe the OBD data to the gauges? If i run an obd simulator that creates various PIDs data in a stream, how could I use OAPs gauges to display it? Perhaps through the pre/post commands parameters?
But that's not really the direction I was going with this topic anyway. I'm wondering if there are any ways to pipe the OBD data to the gauges? If i run an obd simulator that creates various PIDs data in a stream, how could I use OAPs gauges to display it? Perhaps through the pre/post commands parameters?