OBD2 traffic readout via CANBUS - Printable Version +- BlueWave Studio forum (https://bluewavestudio.io/community) +-- Forum: OpenAuto Pro (https://bluewavestudio.io/community/forum-86.html) +--- Forum: OBD-II (https://bluewavestudio.io/community/forum-103.html) +--- Thread: OBD2 traffic readout via CANBUS (/thread-2997.html) |
OBD2 traffic readout via CANBUS - qbs - 10-21-2021 Is there any possibility to read OBD2 data via CAN for OAP? I am already connected to canbus with OAP so all in all there is no need to connect obd2 module. RE: OBD2 traffic readout via CANBUS - Daniel_BlueWave - 10-22-2021 OAP uses direct communication with ELM module for reading OBD data. You would have to simulate this in your case. You can give a try. RE: OBD2 traffic readout via CANBUS - BlueWave - 01-21-2022 Soon we will release OpenAuto Pro with the API that covers injecting value of OBD-II formulas defined in config. That will allow users to implement gathering and displaying data from any source (without establishing OBD-II connection). The API will also allow querying OpenAuto Pro for current value of the gauges defined in config. RE: OBD2 traffic readout via CANBUS - arturk - 03-11-2022 (01-21-2022, 04:10 PM)BlueWave Wrote: Soon we will release OpenAuto Pro with the API that covers injecting value of OBD-II formulas defined in config. That will allow users to implement gathering and displaying data from any source (without establishing OBD-II connection). This is great! Is there estimate time frame when this will be released? I like to feed dashboard gauges directly from CAN BUS (bypassing OBD-II). RE: OBD2 traffic readout via CANBUS - BlueWave - 03-11-2022 It has been released in version 15 of OpenAuto Pro. |