Is it possible to change at wicht state gpio works - Printable Version +- BlueWave Studio forum (https://bluewavestudio.io/community) +-- Forum: Community (https://bluewavestudio.io/community/forum-85.html) +--- Forum: General (https://bluewavestudio.io/community/forum-57.html) +--- Thread: Is it possible to change at wicht state gpio works (/thread-1142.html)

Is it possible to change at wicht state gpio works - ronald001 - 09-21-2019 NOw Its like this way I have set gpio2 for rearcam and gpio 3 for toogle day/nigth mode now its like this way if i turn on pi cam starts automatic and set nigth mode cuz pins are high but i want that rearcam open if gpio pin goes low cuz on my pdc there is one line if pdc goes on this line goes low so i can connect it directli to pdc so is there one way to say setup gpio to low to use funktion? because at this state its like i pit pin low rearcam close i want or better i need it in the other way pin goes low start rearcam i use 3.3.2 rc RE: Is it possible to change at wicht state gpio works - ronald001 - 09-21-2019 for day nigth easy solution i change day to nigth and night to day in service.ini RE: Is it possible to change at wicht state gpio works - Daniel_BlueWave - 09-21-2019 You can check this: https://bluewavestudio.io/community/showthread.php?tid=1015