BlueWave Studio forum
OpenAuto Pro version 13.2 is available - Printable Version

+- BlueWave Studio forum (https://bluewavestudio.io/community)
+-- Forum: Development (https://bluewavestudio.io/community/forum-88.html)
+--- Forum: Updates (https://bluewavestudio.io/community/forum-67.html)
+--- Thread: OpenAuto Pro version 13.2 is available (/thread-2774.html)

Pages: 1 2 3


RE: OpenAuto Pro version 13.2 is available - wkl3968 - 10-07-2021

so, if I install the GPS on RPI, will it uses this GPS or phone GPS?


RE: OpenAuto Pro version 13.2 is available - bendervvs - 10-07-2021

(10-06-2021, 02:05 PM)pedroc1999 Wrote:
(09-19-2021, 11:54 AM)Shugi Wrote:
(08-23-2021, 08:19 PM)bendervvs Wrote: In the waze app, the speed is displayed incorrectly, at a speed of 50 km / h, 98 - 110 km / h are displayed

Hello, I am experiencing the same issue.

When using Waze on AA of the Peugeot 208 of my gf, I have no issue with speed or GPS accuracy. Her radio is a Bosch radio from Peugeot on which we added a cheap GPS under the plastic dashboard just to enable AA.

However, in my car using OAP, I have the same speed issue than you but also some "jumps". My setup is using an external good quality GPS installed right under the windshield (so it shouldn't have accuracy issue compared with the Peugeot). I am wondering if it is possible that Waze is adding the speeds of the phone GPS and the external GPS and kind of switching back and forth between both which could explain the jumps.

Without external GPS, Waze doesn't detect my phone GPS while Maps has no issues at all using it.

I hope someone finds a solution for this. It would be perfect to be able to use Waze on AOP like any other AA solution.

Whether the apps use the GPS offered by OAP (headunit) is upto each apps implementation and iirc, OAP has no say in whether they do or not influence it.

I asked similar question a while back, and sadly its upto the inner workings on AA, which runs on the phone, and OAP is simply a fancy display/monitor for it
This is not at all true, in my case I have the gps uart module installed, and with it the waze app does not correctly display the speed (always in the direction of increasing speed), but the movement of the cursor is completely normal. And if i turn off the gps (service gpsd stop) then the OAP starts using the phone gps and the speed is displayed correctly.


RE: OpenAuto Pro version 13.2 is available - jhornbr225 - 10-20-2021

Just for info, under "Announcements" on the right hand side of the forum page, it says the latest version of Open Auto Pro is 13.1, and the link takes you to the announcement for 13.1.

But the latest version is 13.2.


RE: OpenAuto Pro version 13.2 is available - Daniel_BlueWave - 10-21-2021

Done, thanks for pointing this out.