04-27-2022, 01:36 AM
(This post was last modified: 04-27-2022, 01:51 AM by BoostedGS300.)
Okay so as seen in previous posts, I had some confusion about the controller service. I got that done and saved but things are not working. I also did an IFconfig and I do see the CAN0 appears "up" and according to another post that means the can devices are present, correct? I am using an E60 idrive controller that has more than four wires. Much searching gives me Pin 1 - +12, Pin 2&3 - Ground, Pin 4 - can hi, Pin 5 Can Low. I have all these wires connected to the carpihat accordingly. I also tried pin 2 or pin 3 for the ground.
Now, since things are not working how do I go about troubleshooting? Can I look for can traffic? IFconfig by can0 shows 0 for everything so I assume there isn't any.
I'm not sure where to go from here so any help is appreciated.
Now, since things are not working how do I go about troubleshooting? Can I look for can traffic? IFconfig by can0 shows 0 for everything so I assume there isn't any.
I'm not sure where to go from here so any help is appreciated.