03-17-2023, 08:20 AM
(This post was last modified: 03-17-2023, 08:51 AM by Daniel_BlueWave.)
Unfortunately I still am unable to get it to boot. I have tried some different versions of Pi OS. Not sure what the issue is. Boots fine if just loading Pi OS. Is there a way to install from within Raspi? should I try with direct usb connection from the computer rather than SD?
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
For some reason it still doesn't work. I have followed the steps but I will list out what I did.
I used the raspi installer to install Bullseye 11 current version to the SD card until it completed and ejected the disk. I then put the sd card back in and used Etcher to load OpenAuto the same. I then loaded the SD card on to the Raspi and plugged in to a dedicated usb power source. Power lights come on but never boots. If I load just RaspiOS it boots fine. Is there a specific version of the Raspi OS I should use? I am not sure what I am doing wrong.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
For some reason it still doesn't work. I have followed the steps but I will list out what I did.
I used the raspi installer to install Bullseye 11 current version to the SD card until it completed and ejected the disk. I then put the sd card back in and used Etcher to load OpenAuto the same. I then loaded the SD card on to the Raspi and plugged in to a dedicated usb power source. Power lights come on but never boots. If I load just RaspiOS it boots fine. Is there a specific version of the Raspi OS I should use? I am not sure what I am doing wrong.