03-09-2023, 09:33 AM
Hi to all
I recently purchased openauto pro and Icarplay plugin and I want to install it on my aud RNSE using a pican board. when I try it on a raspberry pi image with no openauto it works fine but with the openauto image it doesent.
I added those lines on /boot/config.txt
[b]dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=25
dtoverlay=spi-bcm2835-overlay[/b]
then rebooted and type this command
[b]sudo /sbin/ip link set can0 up type can bitrate 500000[/b]
[b]but everytime got this answer "Cannot find device "can0"[/b]
[b]what I'm doing wrong?[/b]
[b]Any help would be appreciated [/b]
I recently purchased openauto pro and Icarplay plugin and I want to install it on my aud RNSE using a pican board. when I try it on a raspberry pi image with no openauto it works fine but with the openauto image it doesent.
I added those lines on /boot/config.txt
[b]dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=25
dtoverlay=spi-bcm2835-overlay[/b]
then rebooted and type this command
[b]sudo /sbin/ip link set can0 up type can bitrate 500000[/b]
[b]but everytime got this answer "Cannot find device "can0"[/b]
[b]what I'm doing wrong?[/b]
[b]Any help would be appreciated [/b]