06-13-2022, 08:54 PM
Hello, I'm a bit stumped at the moment. I'm currently trying to map three buttons for scrolling and the enter key for CarPlay. I've tried following the information here:
https://bluewavestudio.io/community/show...p?tid=2208
However, I couldn't get it to work. I've tried using GPIO pins 20, 21 and 26 for 1, 2 and Enter keys respectively but nothing is happening when I try to use them. I got rid of my power management HAT which doesn't even use those GPIO pins and it still doesn't work.
This is how I have the config .ini file set up:
And this is how I have the autostart file set up:
Is there anything here that I've missed out or have done incorrectly? I'm trying not to use a Teensy/Arduino now due to space constraints as I'm mounting this OAP solution on my motorbike.
https://bluewavestudio.io/community/show...p?tid=2208
However, I couldn't get it to work. I've tried using GPIO pins 20, 21 and 26 for 1, 2 and Enter keys respectively but nothing is happening when I try to use them. I got rid of my power management HAT which doesn't even use those GPIO pins and it still doesn't work.
This is how I have the config .ini file set up:
And this is how I have the autostart file set up:
Is there anything here that I've missed out or have done incorrectly? I'm trying not to use a Teensy/Arduino now due to space constraints as I'm mounting this OAP solution on my motorbike.