10-14-2018, 06:01 PM
I've got the B+ GRN and B- all connected to the BWS, but I'm confused to what I need to do next.
What do the OutPut pins connect to from the BWS? If I'm using the USB, do I need to use all the OutPut pins?
Where does the STBY connector hook too? Does it connect to a constant 12V via a resistor? and then to a GPIO (which pin)?
And now looking at the instructions, it looks like I need to also have a 1.8kohm resistor? (If this is required for it to work, it should be included).
IS there software that is needed for the PI? Is there a way to install it remotely? Since I have this all in the car now.
Do you have a passion for cars?
Then create a page for it at Car Audio Central
A great place to document and share your OpenAuto Pro projects.
Then create a page for it at Car Audio Central
A great place to document and share your OpenAuto Pro projects.