Current version of the OpenAuto Pro is 6.1
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
need to install anything on raspberry when using openauto pro?
#1
Hallo,



I finally found the time to test my setup at home bevore I start to install it in the car, but I somehow dont get any feedback when i disconnect standby from 12V



I also checked /var/log/syslog and can not see any message showing up if I plugin the standby or disconnect it.



Do I need to install anything to get it work?

Where can I find the download link?



phlo
Reply
#2
Hi,



please check you setup according to datasheet:

https://bluewavestudio.io/resources/bws_...asheet.pdf



There is also additional software needed for correct ignition detection (page 3):

https://www.bluewavestudio.io/resources/...taller.tar
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)