11-17-2021, 11:11 AM
Is it possible to use Raspberry Pi CM4 with IO board to install and run OpenAutoPro? anything that I need to be aware of?
11-17-2021, 11:11 AM
Is it possible to use Raspberry Pi CM4 with IO board to install and run OpenAutoPro? anything that I need to be aware of?
11-17-2021, 11:43 AM
ok. I should be able to load it from the SD card right? just in case, can I install OpenAutoPro after I have setup the Rasbian on CM4?
11-17-2021, 11:59 AM
(This post was last modified: 11-17-2021, 02:58 PM by Daniel_BlueWave.)
(11-17-2021, 11:43 AM)wkl3968 Wrote: ok. I should be able to load it from the SD card right? just in case, can I install OpenAutoPro after I have setup the Rasbian on CM4? OpenAuto Pro is preinstalled on the image that your received after purchase. There is no install script for OpenAuto Pro on clean Raspberry PI OS. As far as we know CM4 uses the same Raspberry PI OS version as 3B, 3B+ and 4B so at least it should boot with the image received after purchase. However CM4 setup is officially not tested and supported.
11-28-2021, 03:48 PM
Works great. No issues. Just be sure to enable the USB overlay in your boot/config.txt file in accordance with the cm4 documentation.
12-04-2021, 10:01 AM
(11-28-2021, 03:48 PM)Tremws Wrote: Works great. No issues. Just be sure to enable the USB overlay in your boot/config.txt file in accordance with the cm4 documentation. I second this, great part is the IO board even in a case is just under the 178MM or so for DIN width and definately under DIN depth! The route I am going with my build with my "floating" 10.1 IPS display with DIY capacitive touch buttons added to the screen! I am now trying to figure out if I can use a PCIE sound card with the IO board! Hoping wkl3968 can share his findings on the Mazda Commander [size=1][b][url=https://bluewavestudio.io/community/member.php?action=profile&uid=2783][/url][/size][/b]
01-08-2022, 11:38 AM
(This post was last modified: 01-08-2022, 04:28 PM by Daniel_BlueWave.)
I am in the same Boat, @wkl3968 and @ewsoares
I am planing a similar build, would like to share notes. I will be working to get it all working before I start making the unit. |
|