Hey there,
I have my setup mostly worked out, but I'm having issues with the camera freezing the system after 5 seconds of use.
Toggling the pins for the camera, pressing Ctrl+c, signaling the pins attached to the shutdown script, and anything else I try is futile.
I'm running a rpi4 with openauto pro 13.2
Using the MakerFocus Raspberry Pi4 Camera... https://www.amazon.com/dp/B07DPNDP6R
And Arducam CSI to HDMI Cable... https://www.amazon.com/dp/B06XDNBM63
The camera doesn't seem to work with the V4L2 backend, but will on finder when set to 1080(at least for 5 seconds when it freezes)
Running raspivid -t 0 works just fine for up to 5 minutes when I stopped it. And this is repeatable for me. (I saw "script" as a backend type, is it possible to just use something akin to raspivid -t 0 when I trigger the rear cam?) raspivid also has a LOT less delay on screen.
I'm new to the pi and this one has me stumped and my google-fu didn't cut it.
Any suggestions or ideas would be deeply appreciated.
I have my setup mostly worked out, but I'm having issues with the camera freezing the system after 5 seconds of use.
Toggling the pins for the camera, pressing Ctrl+c, signaling the pins attached to the shutdown script, and anything else I try is futile.
I'm running a rpi4 with openauto pro 13.2
Using the MakerFocus Raspberry Pi4 Camera... https://www.amazon.com/dp/B07DPNDP6R
And Arducam CSI to HDMI Cable... https://www.amazon.com/dp/B06XDNBM63
The camera doesn't seem to work with the V4L2 backend, but will on finder when set to 1080(at least for 5 seconds when it freezes)
Running raspivid -t 0 works just fine for up to 5 minutes when I stopped it. And this is repeatable for me. (I saw "script" as a backend type, is it possible to just use something akin to raspivid -t 0 when I trigger the rear cam?) raspivid also has a LOT less delay on screen.
I'm new to the pi and this one has me stumped and my google-fu didn't cut it.
Any suggestions or ideas would be deeply appreciated.