05-24-2021, 10:31 AM
(This post was last modified: 05-24-2021, 01:27 PM by Daniel_BlueWave.)
05-24-2021, 10:31 AM
(This post was last modified: 05-24-2021, 01:27 PM by Daniel_BlueWave.)
05-24-2021, 11:17 AM
Looks like your query received a lot more data than 15 bytes. Did you try to connect directly to the ELM327 via any serial terminal, execute your query by hand and check how the response look like?
Thank for the reply.
Quote:Looks like your query received a lot more data than 15 bytes. when i say 15 Bytes, its Bytes not bit. How do you see I receive more Bytes ? Is there a more verbose Log mode ? Quote:Did you try to connect directly to the ELM327 via any serial terminalI'am not sure how to do this. As I can connect to the wifi hotspot 192.168.4.1 password 1234567890 whith Putty user pi, password raspberry . I could try to use a serial terminal like Minicom.
I used picocom and have this result
ATZ ATL1 ATE1 ATS1 ATH1 ATAL ATSH752 ATCRA772 ATFCSH752 ATFCSD300000 ATFCSM1 ATSP6 2121 772 10 16 61 21 44 35 45 39 772 21 36 33 30 33 20 20 20 772 22 20 20 20 20 20 20 20 772 23 20 20 20 20 20 20 20 Not sure it's good. I made a mistake the header is 744 not 752. I will retry.
05-24-2021, 03:15 PM
Finaly tthe result retuned by OpenAutopro is good but it can't parse it.
should be read like this:
And fro 2121
Should be read :
Then I've just received the 13.1 update, I'll try whith it.
05-27-2021, 03:57 PM
05-28-2021, 09:33 AM
Hello, we will try to prepare similar response and investigate the issue. Will let you know in case of any findings.
|
|