03-15-2021, 09:10 AM
(This post was last modified: 03-16-2021, 07:46 AM by Benvolio.
Edit Reason: Spelling mistake! It was late... ;)
)
Hello everyone. So, I purchased OAP at version 8 and my camera worked, now that I've upgraded to OAP ver 12 it doesn't work at all, not even detected. Thoughts? Help?!
Raspberry Pi model 3B+
Raspberry Pi official 7" screen
Wide-angle Arducam
When I do command
Another error of note is this one:
mmal: Cannot read camera info, keeping the defaults for OV5647
mmal: mmal_vc_component_create: failed to create component 'vc.ril.camera' (1:ENOMEM)
mmal: mmal_component_create_core: could not create component 'vc.ril.camera' (1)
mmal: Failed to create camera component
mmal: main: Failed to create camera component
mmal: Camera is not enabled in this build. Try running "sudo raspi-config" and ensure that "camera" has been enabled
I have checked all connections. Everything works in V 8.0, just not in V 12.0!
I've looked and tried many solutions and none seem to work.
Raspberry Pi model 3B+
Raspberry Pi official 7" screen
Wide-angle Arducam
When I do command
vcgencmd get_camera
I get supported=0 detected=0
Another error of note is this one:
mmal: Cannot read camera info, keeping the defaults for OV5647
mmal: mmal_vc_component_create: failed to create component 'vc.ril.camera' (1:ENOMEM)
mmal: mmal_component_create_core: could not create component 'vc.ril.camera' (1)
mmal: Failed to create camera component
mmal: main: Failed to create camera component
mmal: Camera is not enabled in this build. Try running "sudo raspi-config" and ensure that "camera" has been enabled
I have checked all connections. Everything works in V 8.0, just not in V 12.0!
I've looked and tried many solutions and none seem to work.