12-08-2020, 09:20 AM
I recently bought a Raspiaudio Ultra+ soundcard and installed it on Pi4.
link
After installing the drivers, everything seems to work as expected. Only issue is that my volume levels aren't saved and reset on reboot.
I'm using alsamixer to configure volume levels. Card has onboard speakers+mic and jacks for headphones and external mic.
I reduce the speakers volume to 0 and max out headphones, in order to use my cars AUX.
Despite using
The headphone volume still resets to 0 and speakers set to 30.
I've tried creating a bash script on boot to set the headphones to 100.
But same result.
I'd use the Raspiaudio forums, but they seem.. dead.
Any suggestions? Thanks.
link
After installing the drivers, everything seems to work as expected. Only issue is that my volume levels aren't saved and reset on reboot.
I'm using alsamixer to configure volume levels. Card has onboard speakers+mic and jacks for headphones and external mic.
I reduce the speakers volume to 0 and max out headphones, in order to use my cars AUX.
Despite using
sudo alsactl store
orsudo alsactl --file=/etc/wm8960-soundcard/wm8960_asound.state store
as described here (link)The headphone volume still resets to 0 and speakers set to 30.
I've tried creating a bash script on boot to set the headphones to 100.
amixer -c 0 sset "Headphones" 100%
But same result.
I'd use the Raspiaudio forums, but they seem.. dead.
Any suggestions? Thanks.