08-16-2020, 04:56 PM
Hi Daniel,
I am not getting obd2 data on the gauges. I am connected to an OBDlink SX USB at /dev/ttyUSB0 and have successfully tested AT commands at the command line.
The openauto.log seems to show that it is connected. the last entry is ATZ but does not show subsequent AT commands, I don't know if it should.
[2020-08-16 09:25:25.128396] [0xb0a60010] [debug] [OpenAuto] [ObdManager] start.
[2020-08-16 09:25:30.128714] [0x97c3a140] [debug] [OpenAuto] [ObdManager] device is not active. Trying open.
[2020-08-16 09:25:30.140315] [0x97c3a140] [info] [OpenAuto] [ObdSerialTransport] open result: true
[2020-08-16 09:25:30.140369] [0x97c3a140] [info] [OpenAuto] [ObdDevice] initializing.
[2020-08-16 09:25:30.140409] [0x97c3a140] [debug] [OpenAuto] [ObdDevice] executing init command: ATZ
My system.ini looks like this:
[Obd]
ObdAdapterStartupSequence=ATZ;ATE0;ATS0;ATL0;ATH0;ATSP0
ObdAdapterDescriptor=/dev/ttyUSB0
ObdAdapterBaudrate=115200
ObdProbePeriod=5
ObdDeviceType=1
ObdAdapterRfCommAddress=
ObdAdapterRfCommChannel=1
ObdMaxNoDataResponseCount=100
Any ideas?
Thanks!
I am not getting obd2 data on the gauges. I am connected to an OBDlink SX USB at /dev/ttyUSB0 and have successfully tested AT commands at the command line.
The openauto.log seems to show that it is connected. the last entry is ATZ but does not show subsequent AT commands, I don't know if it should.
[2020-08-16 09:25:25.128396] [0xb0a60010] [debug] [OpenAuto] [ObdManager] start.
[2020-08-16 09:25:30.128714] [0x97c3a140] [debug] [OpenAuto] [ObdManager] device is not active. Trying open.
[2020-08-16 09:25:30.140315] [0x97c3a140] [info] [OpenAuto] [ObdSerialTransport] open result: true
[2020-08-16 09:25:30.140369] [0x97c3a140] [info] [OpenAuto] [ObdDevice] initializing.
[2020-08-16 09:25:30.140409] [0x97c3a140] [debug] [OpenAuto] [ObdDevice] executing init command: ATZ
My system.ini looks like this:
[Obd]
ObdAdapterStartupSequence=ATZ;ATE0;ATS0;ATL0;ATH0;ATSP0
ObdAdapterDescriptor=/dev/ttyUSB0
ObdAdapterBaudrate=115200
ObdProbePeriod=5
ObdDeviceType=1
ObdAdapterRfCommAddress=
ObdAdapterRfCommChannel=1
ObdMaxNoDataResponseCount=100
Any ideas?
Thanks!