Hello
I just purchased openautoPro and installed it, everything seem to work fine but my waveshare 7inch touchscreen is not working properly.
I installed the drivers, but the touch needs to be calibrated... so I launch xinput_calibrator from the terminal, I calibrate it by taping on the cross but then, even if i add the "snippet" generated to etc/x11/xorg.conf.d/99-calibration.conf
Nothing changed (even without restarting, nothing has changed...)
A few days ago when I tried ou crankshaft, this was working...
Any solutions ?
Is openauto pro using X11 ?
Thanks
I just purchased openautoPro and installed it, everything seem to work fine but my waveshare 7inch touchscreen is not working properly.
I installed the drivers, but the touch needs to be calibrated... so I launch xinput_calibrator from the terminal, I calibrate it by taping on the cross but then, even if i add the "snippet" generated to etc/x11/xorg.conf.d/99-calibration.conf
Nothing changed (even without restarting, nothing has changed...)
A few days ago when I tried ou crankshaft, this was working...
Any solutions ?
Is openauto pro using X11 ?
Thanks