07-01-2020, 11:43 AM
Hello everyone, let me preface this by saying that i'm very much new to this.
I recently bought a pi and a Sunfounder 7" touch screen to make an openauto build.
I' ve encountered an issue right out of the gate. This happened at the first startup and the audiocard and bt dongle are still not plugged in, but the pi and openauto are already set up.
Let me start with the specs:
Pi: 4B 2GB
Screen: Sunfounder 7"
Android auto version 5.4.502264
Openauto pro 9.0
Phone: Oneplus A6000, USB debugging on (android 10)
Power supply: only temporary, 5V 4A brick.
Issue:
Everything seems fine with the pi itself apart from an occasional low voltage warning.
When i connect my phone, openauto just displays this screen:
where both commands don't do anything. The phone recognizes android auto as active and connected to my car as does the Pi. I can't figure this out.
Thank you.
I recently bought a pi and a Sunfounder 7" touch screen to make an openauto build.
I' ve encountered an issue right out of the gate. This happened at the first startup and the audiocard and bt dongle are still not plugged in, but the pi and openauto are already set up.
Let me start with the specs:
Pi: 4B 2GB
Screen: Sunfounder 7"
Android auto version 5.4.502264
Openauto pro 9.0
Phone: Oneplus A6000, USB debugging on (android 10)
Power supply: only temporary, 5V 4A brick.
Issue:
Everything seems fine with the pi itself apart from an occasional low voltage warning.
When i connect my phone, openauto just displays this screen:
where both commands don't do anything. The phone recognizes android auto as active and connected to my car as does the Pi. I can't figure this out.
Thank you.