02-10-2020, 06:17 PM
Hello,
I would like the rear view camera to remain active for a few seconds after the GPIO is LOW again (GPIO HIGH: camera active / GPIO LOW: leave camera active for e.g. 15 seconds).
Can you somehow change this with a script or something similar or does it have to be built directly into OAP?
I would like the rear view camera to remain active for a few seconds after the GPIO is LOW again (GPIO HIGH: camera active / GPIO LOW: leave camera active for e.g. 15 seconds).
Can you somehow change this with a script or something similar or does it have to be built directly into OAP?