02-03-2020, 08:57 AM
Hello all,
I have an E60 controller interfaced to the PI via an MCP2515, but have not had any joy getting it working.
Setup via the following steps:
ifconfig can0 shows the network as UP, so presumably the hardware connections are OK?
Are there any other settings I need to change?
The openauto.log does not show any helpful info as far as I can tell.
Any help or troubleshooting steps would be much appriciated
I have an E60 controller interfaced to the PI via an MCP2515, but have not had any joy getting it working.
Setup via the following steps:
MCP2515 configuration:
1. In /boot/config.txt please add:
dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=8000000,interrupt=25,spimaxfrequency=50000
dtoverlay=spi0-hw-cs
2. In /etc/rc.local please add (above exit 0):
/sbin/ip link set can0 up type can bitrate 100000
2. Configuration of IDrive Gen1 controller
Open openauto_controller_service.ini file (located at home directory) and change below parameters to:
[Controller]
Type=2
Interface=can0
DoublePressSpeed=300
ifconfig can0 shows the network as UP, so presumably the hardware connections are OK?
Are there any other settings I need to change?
The openauto.log does not show any helpful info as far as I can tell.
Any help or troubleshooting steps would be much appriciated