Current version of the OpenAuto Pro is 6.1
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OPENAUTO PRO in CITROEN C2
#1
Hi. I have installed the Raspberry PI and safe shutdown circuit now finally after mounting the circuit and the PI in the past week. The setup is so that its not permanently fix, the reason be to gain easy access to the setup if I need to work on the PI or for any other reason. The setup was tested and is working. I gave about 10 seconds for the setup to initiate the shutdown after the ignition is turned of, I could have made it less, but I have taken into account the power bump when the car is started. After 10 seconds the shutdown script is running and after another 15 seconds the PI is completely shutdown. I have set the timer to 35 seconds given enough time for the how system to shut down, before all power is cut to the setup.

My main aim is to use the setup up to run my OBD2 system of the vehicle through a Bluetooth dongle, like I have done with a tablet, and to use it for my navigation setup. The OBD2 setup will be mirrored through Open Auto Pro from my Android phone running Torque Pro.


Attached Files Thumbnail(s)
                               
Reply
#2
Looks nice! I also drive a C2 and I'm trying to get OBD2AA to work. Do you have a PID list for your OBD2? I don't have a scanner to get these PIDs unfortunately...
Reply
#3
(02-02-2020, 02:19 PM)marcb4 Wrote: Looks nice! I also drive a C2 and I'm trying to get OBD2AA to work. Do you have a PID list for your OBD2? I don't have a scanner to get these PIDs unfortunately...
Hi unfortunately not. I am using torque pro through mirroring my cellphone to the open auto pro
Reply
#4
@Wynand thanks again for sharing your project. Shutdown solution seems to be very interesting for a lot of people here. We are happy that you have manage to finish your project in short time and with great result.
Looks good and professional.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)