11-16-2019, 12:46 AM
Hi All,
I need some help/advice. I recently upgraded to the Release Candidate OAP 3.2.2. I have a problem that I haven't seen here anywhere (may be buried somewhere).
My rearview camera works in Raspian and OAP 3.2.2R1. However, it only works in OAP using the button for the camera and then placing the truck in reverse - the camera comes on and displays. When I take the truck out of reverse the camera display goes off. All seems OK so far. When leaving to any other screen in OAP or with Android Auto connected nothing happens when in reverse at all, just displays whatever was on the screen and doesn't switch. I have gpio 22 entered in the appropriate OAP setting. I must be missing something that I could not find on this board...
My PI:
Pi 3B+
HifiBerry Amp2 (works fine and is great)
CoolWoo camera from Amazon
Not using Bluetooth at this time
Have installed the Safe shutdown with relays posted by Mr Skrimo (Thank you for your setup)
Any/all ideas or help will be appreciated
I need some help/advice. I recently upgraded to the Release Candidate OAP 3.2.2. I have a problem that I haven't seen here anywhere (may be buried somewhere).
My rearview camera works in Raspian and OAP 3.2.2R1. However, it only works in OAP using the button for the camera and then placing the truck in reverse - the camera comes on and displays. When I take the truck out of reverse the camera display goes off. All seems OK so far. When leaving to any other screen in OAP or with Android Auto connected nothing happens when in reverse at all, just displays whatever was on the screen and doesn't switch. I have gpio 22 entered in the appropriate OAP setting. I must be missing something that I could not find on this board...
My PI:
Pi 3B+
HifiBerry Amp2 (works fine and is great)
CoolWoo camera from Amazon
Not using Bluetooth at this time
Have installed the Safe shutdown with relays posted by Mr Skrimo (Thank you for your setup)
Any/all ideas or help will be appreciated