The past couple of days I started working on the Open Auto Pro (OAP) setup for my 90 Civic this past couple day I have made some good progress. Originally I started it sometime last year but never got a chance to finish it. Currently, I have about 80% of the hardware and software figure out and working on integrating it into my car. Looking forward to finishing my OAP project and documenting it in the process.
Project Features Specifications:
Automatic shutdown when ignition is turn off
Reverse camera activated in reverse gear
Bluetooth connectivity
Rotary encoders to control music, volume, and navigate around menu
Hardware/Software:
Open Auto Pro
Connected Pro
Raspberry Pi 4 8GB
Raspberry Pi 7" official screen
Kinivo USB Bluetooth Adapter
Time.shop 10 Amp Mini Timer Time Delay Relay
DROK 12V-5V DC buck converter
HiLetgo DC 12V 2 Channel Relay Module
UGREEN USB Sound Card
Atolla 7-Port USB Data Hub
KY-040 Rotary Encoders
Arducam 5MP Camera
Noctua 5V Fan
Micro SD Card Extension
12V Toggle Switch
90 Degree Male To Female USB Extension
Progress Pictures:
Update 6/29/21
Finally figured out a good location for the reverse camera, I ended up replacing the hatch lock cylinder with a 3D printed housing for the camera.
I also finished printing version 2 of the case and working on finishing the wiring
Case V2
Project Features Specifications:
Automatic shutdown when ignition is turn off
Reverse camera activated in reverse gear
Bluetooth connectivity
Rotary encoders to control music, volume, and navigate around menu
Hardware/Software:
Open Auto Pro
Connected Pro
Raspberry Pi 4 8GB
Raspberry Pi 7" official screen
Kinivo USB Bluetooth Adapter
Time.shop 10 Amp Mini Timer Time Delay Relay
DROK 12V-5V DC buck converter
HiLetgo DC 12V 2 Channel Relay Module
UGREEN USB Sound Card
Atolla 7-Port USB Data Hub
KY-040 Rotary Encoders
Arducam 5MP Camera
Noctua 5V Fan
Micro SD Card Extension
12V Toggle Switch
90 Degree Male To Female USB Extension
Progress Pictures:
Update 6/29/21
Finally figured out a good location for the reverse camera, I ended up replacing the hatch lock cylinder with a 3D printed housing for the camera.
I also finished printing version 2 of the case and working on finishing the wiring
Case V2