[RearCamera]
; Path to the camera device descriptor (in case of V4L2 backend)
; This parameter cannot be changed in settings menu of OpenAuto Pro application.
DeviceDescriptor=v4l2:///dev/video0
; GPIO Pin to trigger rear camera view (LOW - hide camera view, HIGH - show camera view)
; This parameter can be changed in settings menu of OpenAuto Pro application.
GpioPin=0
; Show/Hide guideline on camera view
; This parameter can be changed in settings menu of OpenAuto Pro application.
ShowGuideLine=false
; Orientation of the camera view (in case of Finder backend)
; This parameter can be changed in settings menu of OpenAuto Pro application.
Orientation=0
; Command or path to the script that will be executed when rear camera view is triggered (via GPIO pin or Menu)
; This parameter cannot be changed in settings menu of OpenAuto Pro application.
ScriptPath=
; Type of the rear view camera backend.
; 0 - Finder, 1 - V4L2, 2 - Script
; This parameter can be changed in settings menu of OpenAuto Pro application.
BackendType=0
; Width of the camera video stream (in case of Finder backend)
; This parameter can be changed in settings menu of OpenAuto Pro application.
ResolutionWidth=1280
; Height of the camera video stream (in case of Finder backend)
; This parameter can be changed in settings menu of OpenAuto Pro application.
ResolutionHeight=720
; Index of the connected device that will be used as rear camera.
; This parameter cannot be adjusted in settings menu of OpenAuto Pro application.
ViewFinderIndex=0
; Enable/disable volume level change when rear camera is active (GPIO is in High state)
; This parameter can be adjusted in settings menu of OpenAuto Pro application.
VolumeLevelEnabled=false
; Percent of absolute volume level that will be set when rear camera is active (GPIO is in High state)
; This parameter can be adjusted in settings menu of OpenAuto Pro application.
VolumeLevel=70