02-13-2020, 01:23 PM
(02-12-2020, 11:00 PM)skrimo Wrote: Regarding OAP software, what kind of improvements are you expecting anyway? Just asking, because I don't think there's anything you could benefit by using USB3 speed. Boot up time won't be faster, and the system itself doesn't need the resources needed for usb3.
Can't really say I'm expecting anything. Should have just bought a cheap head unit... Bit here I am months later slowly plodding along with no direction haha...
Also, my sd card is 32gb. Will probably just use a flash drive for simple storage until I'm actually using the unit in my vehicle. I'm a test bencher at this point. My project car is looking term and I fall into rabbit holes... I'm here now because I was going to use a8 channel relay board in my rewiring..... Ended up discovering Arduino... Then Pi... Then open auto etc.... Now I'm trying to make my 70s vw bus a smart bus of sorts lol... While finishing the diesel conversion etc....
So yeah, my projects tend to ramble in the wind with my interests lol. Just wanted to see others experience with it.
Thanks for all your work on the forums (YouTube also maybe?).
Cheers!
GFunkbus76
- Working on dual screen setup to run 1976 bus AV and dash... eventually.
- Work in long-term progress lol
YouTube Channel for some related videos