08-11-2019, 11:29 AM
(08-11-2019, 10:50 AM)Daniel_BlueWave Wrote: Screen brightness script has to be applied by each user as some of screens require additional hardware.Thanks for your reply @Daniel_BlueWave when I use the steps listed https://bluewavestudio.io/community/show...hp?tid=672&highlight=screen+brightness the brightness service and the OpenAuto Pro service conflict and can't both access the sensor. I am trying to figure out how OpenAuto Pro gets the command to switch to night mode as the instructions from this forum create /tmp/night_mode_enabled but OpenAuto Pro doesn't seem to look for that file.
In case you are using official RPI screen there should be no issue with getting script from internet and adapt it for your solution.
You can check this:
https://bluewavestudio.io/community/show...hp?tid=672&highlight=screen+brightness
I see from the log that this happens, but I am unsure how to make the script from this forum cause the switch.
mode changed, mode: 1, switcherId: 12
updating mode, mode: 1, switcherId: 12