Is there a version 2 coming? or new stock due soon? - Printable Version +- BlueWave Studio forum (https://bluewavestudio.io/community) +-- Forum: Hardware for head-unit (https://bluewavestudio.io/community/forum-87.html) +--- Forum: Power Supply BWS CAR PS (https://bluewavestudio.io/community/forum-61.html) +--- Thread: Is there a version 2 coming? or new stock due soon? (/thread-755.html) |
Is there a version 2 coming? or new stock due soon? - mentalinc - 04-10-2019 Just wondering if there is an ETA for them? Re: Is there a version 2 coming? or new stock due soon? - BlueWave - 04-10-2019 Re: Is there a version 2 coming? or new stock due soon? - Albino_Hedgehog - 04-26-2019 This sort of hardware is very make or break for this sort of project. Is it definitely coming back in stock? Or should I focus on looking for an alternative? Re: Is there a version 2 coming? or new stock due soon? - BlueWave - 05-04-2019 For now you can try Hisma solution which is very simple and interesting: https://bluewavestudio.io/community/showthread.php?tid=724 Re: Is there a version 2 coming? or new stock due soon? - mentalinc - 05-06-2019 Re: Is there a version 2 coming? or new stock due soon? - BlueWave - 05-06-2019 What do you mean, by this? Quote:can't see why it wouldn't work! Re: Is there a version 2 coming? or new stock due soon? - mentalinc - 05-17-2019 I have now done that and works 100% as expected. Suggest you point people in that direction. I wrote up what the video did to help along on my build: ### Resetting Timer to the factory settings. ### To reset the timer to the factory settings perform the following procedure: Connect WHITE/GREEN wires to the ground or push button #1 and #2. Supply power to the timer. When output comes on (LED ON) disconnect power while keeping WHITE/GREEN wires connected to the ground. Repeat supply and disconnect of power five times. On the fifth time, the output will blink a couple times. Disconnect WHITE/GREEN from the ground and wait until LED goes OFF. Disconnect power. Timer is reset to the default values. ### Wiring ### Blue = GPIO Red = power Black = ground Yellow & Red Light goes to yellow and black Battery goes to red and black ### HMS Mode ### Touch GREEN and WHITE to GROUND, apply power, then remove GREEN and WHITE from GROUND, light should stay on three seconds = programming mode Touch GREEN and WHITE to GROUND four more times (waiting for the light to turn off each time) Touch GREEN to GROUND,, then take GREEN off GROUND, light should flash twice Pull power ### Set to shut off after 1 hour ### Touch GREEN and WHITE to GROUND, apply power, then remove GREEN and WHITE from GROUND, light should stay on three seconds = programming mode WHITE touch and hold to GROUND 4 times = four paramters (light will "strobe" watch and follow then VERY quickly touch WHITE to GROUND so light just flashes to set 1 hour WHITE to GROUND and hold to save. light flashes a few times then WHITE to GROUND 4 more times (light flashes for a bit) to skip the paramters, then the light says on after fourth touch remove power ### Delay time off type ### Touch GREEN and WHITE to GROUND, apply power, then remove GREEN and WHITE from GROUND, light should stay on three seconds = programming mode Touch GREEN and WHITE to GROUND once - light stays on for a bit WHITE to GROUND 12 times (light on each time) wait a bit then GREEN to GROUND two touches remove power |