08-01-2021, 07:23 PM
Originally used for a carpc build, I decided to repurpose the frame for OAP.
Originally in a 1999 ranger, moved to 1988 mustang when I sold the ranger.
upgrading for re-use in the mustang.
frame is aluminum, machined from a solid piece 1/2 " thick.
slot in the back of button area has been milled to accept some micro switches from an old yamaha receiver that where cut out from a larger circuit board.
buttons machined from some grey nylatron I had laying around, with the red power button machined from polyurethane.
waiting on some header breakout boards to attach the buttons to the gpio's.
I'll update as I continue the build.
Originally in a 1999 ranger, moved to 1988 mustang when I sold the ranger.
upgrading for re-use in the mustang.
frame is aluminum, machined from a solid piece 1/2 " thick.
slot in the back of button area has been milled to accept some micro switches from an old yamaha receiver that where cut out from a larger circuit board.
buttons machined from some grey nylatron I had laying around, with the red power button machined from polyurethane.
waiting on some header breakout boards to attach the buttons to the gpio's.
I'll update as I continue the build.